Fault diagnosis method of optical fiber fusion splicer

Fault diagnosis method of optical fiber fusion splicer

Optical fiber fusion splicer after long time use will inevitably there are some problems, some time is fatal breakdown of the machine, such as damage to the internal parts, this time need to return to factory maintenance, but most of the time are some simple fault, the users themselves can be resolved, as welding machine users to their own machine maintenance and judge and solve simple problems is very important.
Optical fiber fusion splicer is a precision instrument can be divided into hardware, software, and supplies to understand. At the same time, we can also likened to a gun to explain the role of each component.
I. as part of the hardware, V groove is the barrel of a gun, if not in a straight line, playing out of bullets to crooked, fiber and are not allowed to; fiber presser foot is sight, problem cannot be fixed optical fiber.
II. as part of the software, the light path of the optical fiber observing is like our eyes, not clearly could not finish the control core, and the firmware of the interior of the machine is like our minds to often make it in the new state.
III. as part of the supplies, welding machine is only electrode bar, this is like a bullet, if appear to bomb bad, the serious results can be imagined.
So we in the use and maintenance of welding machine, you need to use above methods to treat machine, which is particularly important, we often in the television see liberation army before going to wipe gun, that is because to prevent war gun jammed, the same melting machine inside also can not be accumulated dust and garbage, we after the completion of daily work must be the welding machine to clean up and then put into carrying box, otherwise waste accumulate over a long period of time will eventually lead to welding machine failure.

Fusion Splicer

Share this post