How to use the fiber cleaver?

How to use the fiber cleaver?

Fiber cleaver, which is a fixed a certain way for cutting the fiber optic cable, such as device, main effect is to realize the standard smoothness and smooth incision, preparing for the next step of the optical fiber welding.
Operation method:
1, confirm the device has a blade sliding plate at the front end, open the platen size;
2, with peel fiber pliers strip optical fiber coating layer, the reserved long naked degrees for 30 to 40 mm, dip in with alcohol cotton wool or cotton paper fiber, then wipe off the fiber.Use absorbent cotton or cotton paper to wipe a, don’t use the same cotton wool or cotton paper to wipe the second (note: please use the purity is more than 99% alcohol).
3, visual optical fiber coating layer on the edge on the cutter rod (12 ~ 20 cm) after the appropriate scale, left hand to press the fiber into the guide groove, require bare fiber straight on the left and right rubber MATS.
4, close the small plate, pressure plate, driving device with blade slider, make blade row cut fiber under the surface, and free sliding to the other side, to cut off the fiber;
5, the left hand to hold the cutter, the right hand to open the clamp and remove fiber debris, in fixed container.
6, knead a optical fiber at the same time, the right hand with his left hand to open small clamp, carefully remove the cut end face of optical fiber, note: clean the optical fiber section don’t touch other things.

 fiber cleaver

Share this post