Related Posts
How to splice optical cable with fusion splicer
The ends of the fibers are aligned with a fusion splicer and then fused together with a current. Before,... read more
The use of the optical power meter
The use of optical power meter first need to have several conditions: a glowing light source (light source device... read more
Discussion on Melting Point Reinforcement of Fusion Splicer
1. Slide the fiber heat shrink tubing to the center of the weld and place it in the heater... read more
The reason why fusion splicer shows can not find the fiber!
The factors that lead to the failure can be analyzed from the following points: 1.Left fiber (right fiber) placed incorrectly,... read more
What is the difference between a fiber cutter and a wire cutter?
The fiber cutter and the wire cutter of the communication industry are the same type of cutter, but the... read more
How is the submarine cable laid?
The submarine communication cable is a wire wrapped with insulating material and laid on the seabed to complete the... read more
Three forms of absorption loss of fusion splicer
The absorption loss of the fusion splicer is mainly due to the absorption of light energy by the optical... read more
Fusion splicer: why replace the electrode bar
Rod electrode is consumption accessories of fusion splicer, so many friends do not understand why to replace the electrode... read more
Disposing Method of Fusion Splicer Cannot Discharge
Fusion splicer failure: Discharge connection, the use of factory settings (1 ~ 5) discharge procedures are not available, the... read more
The Operational Principle of Optical Power Meter
Firstly, It is transmitted over the optical signal is projected on the photosensitive surface of the PIN photodetector to... read more